Iranian Research Organization for Science and TechnologyJournal of Particle Science and Technology2423-40872220160601Effect of ion concentration on viscosity, electrical conductivity and deposit weight of doped nano alumina prepared by electrophoretic deposition556842010.22104/jpst.2016.420ENMostafaMilaniAdvanced Materials & Renewable Energies Department, Iranian Research Organization for Science and Technology, Tehran, IranSeyed MohammadMirkazemiSchool of Metallurgy and Materials Engineering, Iran University of Science and Technology, Tehran, IranSeyed MohammadZahraeeAdvanced Materials & Renewable Energies Department, Iranian Research Organization for Science and Technology, Tehran, IranJournal Article20161125Viscosity, electrical conductivity and deposit weight were determined for Electrophoretic deposition (EPD) Mg2+-, Y3+-, La3+- and Ce4+-doped alumina's ethanolic suspensions prepared at dopant concentration between 350 to 1350 ppm. The concentration of XCly (X, y were: Mg, 2; Y, 3; Ce, 3 and La, 3, respectively) the charging salt, is also found to be a critical factor to control the viscosity. It is shown that the deposit weight is influenced by precursor concentration, but not by conductivity, viscosity or the pH of the suspension. All two way concentration interactions without Mg2+ and Ce4+ concentration simultaneous change are significantly in analysis of variance (ANOVA) model. The viscosity of suspension reached 2.5 mPa.s with Mg2+-, Y3+-, La3+- and Ce4+- decreased to 100, 100, 100 and 0 ppm in low iodine concentration (400 ppm), due to the most heavily cations that can adsorb to alumina surface with iodine adsorption but lighter Mg2+- cations adsorb under the influence of OH groups excite on alumina surface. The interest in the present study is to achieve a model between viscosity and additive concentration.Iranian Research Organization for Science and TechnologyJournal of Particle Science and Technology2423-40872220160601Synthesis of pure monoclinic zirconia nanoparticles using ultrasound cavitation technique697740110.22104/jpst.2016.401ENMaryamRanjbarDepartment of Chemical Technologies, Iranian Research Organization for Science and Technology (IROST), Tehran, IranMostafaYousefiDepartment of Chemical Technologies, Iranian Research Organization for Science and Technology (IROST), Tehran, IranMahboobehLahootiDepartment of Chemistry, Faculty of Sciences, Damghan University, Damghan, IranSeyed HeydarMahmoudi NajafiDepartment of Chemical Technologies, Iranian Research Organization for Science and Technology (IROST), Tehran, IranAzizmMalekzadehDepartment of Chemistry, Faculty of Sciences, Damghan University, Damghan, IranJournal Article20160830In the current study, synthesis and characterization of a new nano-structured zirconium(IV)-minoxidil complex (1), where minoxidil, (C<sub>9</sub>H<sub>15</sub>N<sub>5</sub>O; 6-(1-Piperidinyl)-2,4-pyrimidinediamine 3-oxide), have been investigated in two different solvents. The compound (1) has been synthesized by sonochemical method in the presence of methanol and monoethylene glycol (MEG) as solvents and characterized by scanning electron microscopy (SEM), Fourier transform infrared (FT-IR) spectroscopy and elemental analysis. The thermal stability of the compound 1 has been studied by thermalgravimetric (TGA) and differential thermal analyses (DTA). Pure monoclinic (m) zirconia (ZrO<sub>2</sub>) nanoparticles were readily synthesized from thermal decomposition of the compound 1 as a new precursor in both solvents. The products were characterized by FT-IR, XRD, and SEM to exhibit the phase and morphology. The results showed that, pure zirconia was produced with particles size of 53 nm and the crystal system was monoclinic when methanol was used as solvent in complexation process. While the particles size of zirconia with the same structure were significantly reduced to 25 nm, using MEG as solvent. This study demonstrates that the coordination compounds may be suitable precursors for the simple one-pot preparation of nano-scale metal oxides with different morphologies.Iranian Research Organization for Science and TechnologyJournal of Particle Science and Technology2423-40872220160601Effects of Temperature and Particle Size Distribution on Barite Reduction by Carbon monoxide Gas798541310.22104/jpst.2016.413ENSaeedVakilpourDepartment of Metallurgy and Materials Engineering, Hamedan University of Technology, Hamedan, IranAhmadGhaderi HamidiDepartment of Metallurgy and Materials Engineering, Hamedan University of Technology, Hamedan, IranJournal Article20161106In this research, a mineral barite powder was reduced by carbon monoxide gas and the effects of reduction time and temperature was investigated as well as barite particle size. Results showed that the best result would be feasible when the barite particle sizes are between (-70 +100) in mesh scale. The barite reduction could reach the maximum level (98%) after reduction by carbon monoxide at 850°C for one hour. Meanwhile, the same amount of reduction could have been achieved in shorter time intervals at higher temperatures. The kinetics model for reduction process was also determined and activation energy was calculated.Iranian Research Organization for Science and TechnologyJournal of Particle Science and Technology2423-40872220160601Effect of Sn Doping on Structural and Optical Properties of 2D α-MoO3 Nanostructures879341410.22104/jpst.2016.414ENAminEftekhariDepartment of Physics, Shahrood University of Technology, Shahrood, IranMohammad BagherRahmaniDepartment of Physics, Shahrood University of Technology, Shahrood, IranFatemehMasdarolomoorDepartment of Chemistry, Shahrood University of Technology, Shahrood, IranJournal Article20161117Undoped and Tin (Sn) doped Molybdenum trioxide (α-MoO3) nanostructured thin films (which has lamellar (2D) structure) have been prepared using a simple and cost effective technique of spray pyrolysis on glass substrates at 450 ℃. Surface morphology, optical and structural properties of samples have been investigated using FESEM, UV-Vis spectroscopy and XRD analysis techniques, respectively. FESEM images showed the formation of some discrete micro-spheres on the surface, which with the increasing in the amount of dopant homogenous and dense nano-platelets was grown on top of these micro-spheres. The XRD pattern analysis shows that all samples have been grown in orthorhombic (α-MoO3) crystal structure and except for the sample doped with 50 at% Sn which had a weak peak of SnO2, no peak have been observed corresponding to the incorporation of Sn. By increasing the amount of impurity, optical transmittance of samples were increased from ~27 to 50%. Also, the band gap of samples were calculated using transmission data. An increasing of band gap from 3.34 to 3.89 eV was observed with increasing in the amount of doping.Iranian Research Organization for Science and TechnologyJournal of Particle Science and Technology2423-40872220160601Energy Modeling and Simulation including particle technologies within Single and Double Pass Solar Air Heaters9510245510.22104/jpst.2016.455ENFahimehEbrahim AsghariDepartment of Energy, Materials and Energy Research Center (MERC), Tehran, IranHosseinGhadamianDepartment of Energy, Materials and Energy Research Center (MERC), Tehran, IranMohammadAminyDepartment of Energy, Materials and Energy Research Center (MERC), Tehran, IranJournal Article20161225In order to obtain the best performance of the solar air heaters, it is necessary to find optimum performance conditions. The aim of this research paper is to achieve optimum conditions, by comparing single and double pass solar air heaters. Also, a brief review study of various related research works of all scenarios for a single and double pass and packed bed (including particle technologies) solar air heaters was carried out to observe the challenges of the mentioned systems. Energy modeling and simulation with EES and MATLAB open source code software indicated significant results in efficiency. According to the obtained results, it can be explained that double pass duct not necessarily always increases the overall system energy efficiency. Results of this work indicate, higher ambient air temperature (inlet air temperature) and lower solar irradiation can increase overall energy efficiency of solar double pass systems. More precisely at solar irradiation of 916 W/m2 and inlet air temperature of 302 οK, the system achieves the targeted optimum value in energy efficiency, approximately 90%, which is considerably more than the 65% as an average value.Iranian Research Organization for Science and TechnologyJournal of Particle Science and Technology2423-40872220160601Thin film nanocomposite forward osmosis membrane prepared by graphene oxide embedded PSf substrate10311741210.22104/jpst.2016.412ENSaharnazTajikDepartment of Chemical Engineering, Faculty of Engineering, University of Isfahan, Isfahan, IranOmidMoini JazaniDepartment of Chemical Engineering, Faculty of Engineering, University of Isfahan, Isfahan, IranSoheilaShokrollahzadehDepartment of Chemical Technologies, Iranian Research Organization for Science and Technology (IROST), Tehran, IranSeyed MahdiLatifiDepartment of Chemical Technologies, Iranian Research Organization for Science and Technology (IROST), Tehran, IranJournal Article20160813One of the limiting factors in good performance of forward osmosis (FO) membranes is the internal concentration polarization (ICP). To reduce ICP, thin film nanocomposite forward osmosis (TFN-FO) membranes were fabricated by adding different amounts of graphene oxide (GO) nanoplates (0-1 wt. %) to polymer matrix of polysulfone (PSf) substrate. The prepared nanocomposite membranes exhibited both hydrophilicity and porosity higher than that of neat PSf counterpart. An optimum amount of 0.5 wt% was obtained for GO addition into the membranes. The corresponding fabricated thin film nanocomposite (TFN) membrane (TFNG0.5) revealed a water permeability of 2.44 L/m2hbar which is 66% higher compared to an in-house made composite membrane. The FO performance of TFN was assessed by DI water as feed solution and 1 M NaCl as draw solution in AL-DS orientation. The water flux of the synthesized FO membranes increased upon adding of GO nanoplates and reached to a maximum water flux of 37.74 (L/m2h) for TFNG0.5 membrane. This flux is about 3 times higher than TFC membranes without significant changes in their salt rejection. The higher water flux of the TFN membranes can be attributed to ICP decrease originating from reduction of structural parameter of the membranes.